Beko Compressed Air Technology
-
Process Technology
BEKOKAT®
BEKOKAT: for demanding specifications
As far as highly-sensitive applications are concerned, conventional compressed-air processing has technical and economic limits. BEKOKAT sets new standards in the compressed-air processing with a trend-setting catalysis technology. The device fully converts hydrocarbons into carbon dioxide and water through total oxidation.
Constantly oil-free compressed air of a very high quality
BEKOKAT makes achievable constantly oil-free compressed air with a maximum residual oil content of a barely measurable 0.001 mg/m³ of compressed air. A quality level which is required in particularly demanding production processes. The condensate accumulating during the cooling-down of the compressed air is also absolutely oil-free and can flow into the sewerage system without being processed. The enormously long service life of the special granular material of the BEKOKAT is also extremely advantageous as far as profitability is concerned: it only needs to be replaced after a good 20,000 operating hours. The BEKOKAT® advantages at a glance: • Constantly oil-free compressed air, better than ISO 8573-1, class 1 oil content
• Independent of the ambient temperature, air humidity and initial oil concentration
• Environmentally friendly, no hazardous waste. Clean, oil-free condensate
• Partial load operation without restrictions. Long service lives
• For absolute process reliabilityBEKOBLIZZ®
BEKOBLIZZ: highest demands on dryness and coldness
In most cases, an increase in production and quality stands in direct relation to the quality of the compressed air applied during manufacture. This applies particularly to cooling processes. The BEKOBLIZZ compressed-air freezing system supplies top-grade, dry compressed air with lowest temperatures constantly down to below -35°C / - 45°C.
More productivity through specific cooling
Through the employment of dry and chilled compressed air, manufacturing processes in a wide range of industrial applications can be performed more economically. In parallel, the quality of the products is also improved. In addition, the effective reduction of cycle times also saves time and money.
BEKOBLIZZ is the answer to capacity shortages, the growing cost pressure and increasing quality requirements. The compressed-air freezing system reduces cycle times during blow moulding, increases the capacity in the gas injection technique (GIT), reduces cooling periods during rotation sintering and improves the surface during thermoforming.The BEKOBLIZZ® advantages at a glance: • Effective reduction of cycle times in the production process
• Quality improvement through consistent cooling
• Use of a cost-effective cooling medium
• CO2 and N2 are not required!
• Fully automatic operation
• Short payback periodBEKOBLIZZ® LC
BEKOBLIZZ LC: environmentally friendly cooling at +5°C
BEKOBLIZZ LC cools economically with compressed air with a temperature of +5°C – without applying CO2 or N2. The compressed-air cooler is employed, for example, in the laboratory, in the workshop or in production.The economic alternative
Overcoming capacity shortages, reducing the cost pressure and improving quality: challenges for the climatisation or cooling in production processes.• Cold compressed air of +5°C
• Easy installation, safe operation
• Enhances the process reliability
• Optimum productivity through reduced cycle times
• Short payback period, in many cases less than 12 months